rig out

英 [ˈrɪɡ aʊt]

美 [ˈrɪɡ aʊt]

网络  打扮; 装配; 装扮

英英释义

verb

• put on special clothes to appear particularly appealing and attractive
  1. She never dresses up, even when she goes to the opera
  2. The young girls were all fancied up for the party
  Synonym:overdressdress upfig outfig updeck upgussy upfancy uptrick updeck outtrick outprinkattireget uptog uptog out

双语例句

• The sergeant will rig you out.
  中士将发给你物品。
• The following aspects have been carried out in the design of an AC servo feed system experiment rig based on Motion Controller with FPGA in this thesis: ( 1) A kind of AC servo feed system scheme is given out.
  本文在设计这个基于FPGA运动控制器的交流伺服进给系统试验台上主要做了以下方面的研究：（1）设计了一种交流伺服进给系统方案。
• The load analysis and calculation for the rig under the wave action are carried out. Based on this, three dimensional finite element strength analysis is conducted.
  展开了该平台波浪载荷的分析计算，在此基础上对主体结构进行了三维有限元强度分析。
• I rigged myself out in thick jeans and heavy belt
  我穿上厚厚的牛仔裤，系上重重的皮带。
• The paper analyses functions and characteristics of all kinds of workover rig, proposes out existing problems during well workover.
  文中分析了各类型号修井机的功能和特点，提出了在修井过程中存在的问题；
• Author point that the development emphasis of Chinese domestic on mobile rig design still on the imitation and parts selection, few investigation was carried out on the design theory and match principal.
  论文指出国内的研发重点还是在模仿与部件的选型上，对于部件本身的设计原则、配套理论很少进行研究。
• The rig tongs hinge pin, latch lock and springs must be inspected at regular intervals and changed out if excessive wear is encountered.
  必须定期检查大钳的折页销子，扣合头和弹簧，如果出现磨损超标，就更换。
• It also gives out the concrete form of the compounded control system design, introduces the present actual state of the electric drive drill rig, and points out its developing directions.
  给出了复合型控制系统设计的具体形式，介绍了当前电驱动钻机的现状，指出了其发展方向。
• It provides students the oil rig automation, intelligent learning delivery platform, drilling rig for the conduct of modern research and development, provide the interface to carry out fundamental research.
  该实验装置可以为学生进行石油钻机自动化、智能化研习提供平台，同时为进行现代钻机研发、开展基础理论研究提供接口。
• Based upon the analysis of the working conditions in the tunnel excavations, a principle design, hydraulic value design and system integration design of hydraulic drive system of cutter head for simulator test rig is carried out theoretically with electro-hydraulic proportional control technique.
  论文以盾构模拟试验平台为研究对象，模拟实际盾构施工过程中的工况要求，采用电液比例控制技术对盾构模拟试验平台刀盘液压驱动系统进行了原理设计、液压阀块设计和系统集成设计。